Opinion
Printed Circuit Design & Fab Online MagazineOpinion

Tried-and-True Design Practices for High PCB Yield

In PCB design, design for manufacturing (DfM) is all about correcting mistakes after reviewing a PCB layout. We then devise corrective actions to fix those mistakes and improve procedures to make ...
Circuit Digest

How to Use Height Hold Mode in LiteWing ESP32 Drone?

Now, to use the height hold mode, make sure to select the height hold mode in the Assist mode dropdown menu. You can set your ...
IEEE

Three-Level NPC Converter Switch-Open-Circuit Fault Localization for PMSG-Based WTS Using Estimated Phase Angle Deviation Scheme

Abstract: This research proposes a new method to localize multiple switch-open-circuit (SOC) faults in a high-power wind turbine system (WTS) with a permanent magnet synchronous generator (PMSG) and a ...
IEEE

Design of a Time-to-Digital Converter and Calibration Circuit Based on FPGA

Abstract: This paper presents a high-resolution time-to-digital converter (TDC) implemented on FPGA. The design combines the direct counting method with a tapped delay line architecture, and ...